小型制藥冷凍干燥機使用注意事項

1. Prohibit the use of pipelines as a load-bearing escalator

禁止使用管路作為承重扶梯。

2. It is needed to read the operational manual carefully before operating the machine and only the operator who has been trained and qualified can operate the machine.

 設備操作前請操作人員仔細閱讀使用說明書，在經過培訓合格后方可進行機器的操作。

3.  In order to prevent the virus from destroying the computer used for controlling the equipment, it is forbid installing other software and connecting with other moble equipments.

隨機電腦作為機器操作用電腦，禁止使隨意安裝其他軟件，禁止與其他移動硬件設備連接，防止電腦病毒的侵入；

4. Please ensure the vials are on the shelf uniformly before performing the stoppering procedure. Otherwise the vials may be damaged because of the uneven power. The vial shall be placed on the shelves uniformly even there are no enough vials to be filled with the shelf.

在進行壓塞操作之前，必須保證西林瓶均勻地布滿每塊板層。如果西林瓶沒有均勻地布滿板層，在進行壓塞操作時會有壓碎西林瓶的風險。如果西林瓶不夠布滿整塊板層，也要保證西林瓶均勻的分布在板層上。

5. The aseptic filter shall not be disassembled during the usage, because the aseptic filter may be in low-pressure or high-pressure state.

無菌過濾器可能處于過壓或欠壓狀態，設備使用當中禁止拆卸。

6. It is recommended to use the nitrogen gas to detect the system leakage to avoid the danger.

當需要對有關系統進行檢漏，建議采用氮?dú)獯驂海灰捎闷渌麣怏w，以免發生危險。

7. Please cut off the power supply for PLC and all electric equipment to avoid voltaic interference when performing the weld operation around the lyophilizer.

在凍干機上或附近進行任何焊接操作前，請切斷對PLC及所有電子設備的供電，以確保焊接電弧干擾不會對電子設備造成損壞。

8. The hydraulic cylinder safety pressure:

The working pressure for stoppering cylinder: 20~80bar

The working pressure for mushroom valve cylinder: 20~60bar

The maximum working pressure shall not exceed 80bar

If the pressure is set out of the allowable range, there may be some damages to the equipment. Please contact with the manufacturer.

油缸液壓工作安全壓力：

板層升降油缸工作壓力：20~80bar

蘑菇閥油缸工作壓力：20~60bar

油缸大工作壓力不能超過80bar

超過上述壓力運行，可能會對機器造成損壞，及時與廠家聯系；

9. Open the cabinet door, please confirm the main power is off. If the UPS is installed, even though the main power on the cabinet is off, there is still high-voltage danger, please refer to the relevant electric chart to obtain the detailed information

打開電器柜門前，請確認總電源關閉。如果設備安裝了UPS電源，即使關閉了電器柜總電源開關，仍然存在高壓電危險。請查閱相關電器圖紙

上海拓紛機械設備有限公司！！！